Best SMD6 Guía de instalación descargar pdf (Pagina 4)

MODELS SMD6 • SMD8

Page 4

Regular maintenance is necessary to ensure the proper operation

of the Damper system. Failure to conduct such routine maintenance

can jeopardize the ability of the Damper to introduce fresh air into

the home. Regular maintenance should include the following

activities:

• Cleanthe outsidebirdscreento ensureit isfreefromdebris

and open to allow fresh air to enter.

• Cleanorreplacetheinteriorfilter(s)whichservetofilterfreshair

before it enters the home.

• Maintainaclearopeningattheoutdoorendcap,whichmeans

preventing the buildup of snow, leaves, or vegetation at the end

cap.

• During regular HVAC maintenance, have the mechanical

contractor inspect the Damper system for proper operation.

MAINTENANCE

DAMPER LINKLOGIC™

CONTROL LINK INSTRUCTIONS

1. LinkLogic™ devices communicate via the power line. A phase

coupler is required if LinkLogic™ damper control and master de-

vice (such as LinkLogic™ enabled range hood or SmartSense

control) are wired to opposite electrical phases.

2. MakesurepowerisappliedtoLinkLogic™dampercontroland

master device.

3. Start master device link process per its installation instructions.

4. When instructed, using a small screwdriver or paperclip, press

SET button for 3-seconds to activate damper control’s link

mode.

5. After exiting master device link mode, turn master device on

and off and check damper control on and off accordingly.

After link is established, damper control will remain in its initial

state until master device is turned on and off.

Damper control’s LED is on when damper is open and off when

damper is closed.

6. If LinkLogic™ enabled range hood does not cause damper

controltoturnonandoff,checkthatPLM(power-linemodem)

jumpersareproperlyinstalled. Refertorangehood andPLM

installation instructions.

A qualified HVAC contractor should also ensure the proper

operation and venting of all combustion equipment in the home.

7. LinkLogic™ damper control can be linked to multiple master

devices. If damper control is not turning off with newly linked

master device, make sure another device is not on, which would

cause the damper to remain on (open).

8. In order to erase damper control links and return it to factory

default state, proceed as follows.

a. Remove power from damper control.

b. Press and hold SET button for 10-seconds (LED may light

when SET button is pressed and then dim to off).

c. Continue holding SET button and turn power on.

d. LED should be on when SET button is pressed and power

is applied.

e. After 3-seconds, release SET button.

f. After 3-seconds, LED should light.

g. If LED does not light, repeat this process.

LED

SET

BUTTON

1 2 3 4 5 6 7 8 9 ... 15 16

Comentarios a estos manuales

Sin comentarios

Best SMD6 Guía de instalación Pagina 4

Comentarios a estos manuales

Relacionado con productos y manuales para No Best SMD6